He would be glad if we help to clarify the life of Ross Lynn Valentine.Please contact rudihddhispeed.ch and mark Ross Lynn in the subject of your mail if you can help.The gun was given post mortem to the daughter (we think) of Ross Lynn Valentine.The gun, as you can see, is in presentation style display and shows no sign of firing.
The gun was found in a chest while my great aunt was going through her recently deceased daughters belongings. Its a Small Frame Safety Automatic Hammer First Model.32 Smith Wesson centerfire 2nd variation and made at the end of 1896 when the production stoped and had the single top post latch. Iver Johnson Shotgun Identification Serial Number A50001 AndThe Second Model started in 1897 at serial number A50001 and was made with the double top post latch. Iver Johnson Arms Works Topbreaks (Safety Hammer).32 cal. Perhaps, if you find one thats a bit of a beater you can get it running for a little time and money. Depending on the model or type of firearm, this can vary between simple fixes to get it running again to an almost full restoration. The main difference between an Iver Johnson model and a U.S. Revolver model was that they lacked the Hammer the Hammer action of the regular line and the hammerless version did not have the safety on the trigger. The grips were marked US instead of bearing the distinctive Owls head logo. These little revolvers were built primarily for the export model and mail order sales as opposed to being found for sale in the typical gun shop, hardware store or department store that carried Iver Johnsons name brand revolvers and they never appeared in company catalogs. Ours is an early model as it uses a flat mainspring as opposed to a coil spring. The plastic grips were notorious for cracking due to over tightening of the screw or simply banging into things while being carried. The replacement grip on this example had been carved out of a piece of wood and was honestly a reasonably good fit. Thats what we thought going into this, but the Bubba who repaired this one made the task not so simple. Iver Johnson Shotgun Identification Driver And TappingA little prying with a screwdriver and tapping with a plastic hammer seemed to remedy this. Then we noticed that the grip screw through the grip was stacked with a bunch of steel and copper washers. We remedied this with a metal file to bring the pin back into shape. They supply several screw lengths, but we still had to cut one of the screws by 2mm to fit. We had only seen pictures of these in books and never on an actual Iver Johnson and knew they were on the rare side. Other than that, everything about the revolver was in good working order. We figured if we could not fix it, we at least had a nice set of grips for one of our other Ivers. We relocated the grips to a large frame safety hammerless model and put the shorter grips on this one. A single shot.410 with a homemade forend that was literally held on with bailing wire and electrician tape. The poorly fitting forend interfered with cocking the gun and lockup. The stock was rough, the blue was gone, but surprisingly the original plastic butt plate was in fine condition. We were looking for a similar forend to restore an Iver Johnson Champion in 16 Gauge and received this one instead, so we held onto it for a future project. We could have gone Cerakote, but really did not want to sink a ton of time, money and prep work into a 15 shotgun. Ours will be used giving the grandchildren some shotgun lessons over the summer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |